XDS100v2 仿真器 支持DSP DM3730 CortexR4 CortexA8 OMAP3530
The XDS100v2 USB JTAG Emulator is the second release of the XDS100 JTAG emulator technology supporting debug of a variety of TI devices. It allows the user direct access between the host computer and the DSP through a 14-pin JTAG header. It is compatible with Code Composer Studio (CCS) V4 IDE from Texas Instruments and compatible with Windows 2000/XP/Vista. It can be used for debugging EMA DEV3530 and SBC3530 series OMAP3530 Boards.
Features
- Support for the following processor cores: TMS320C28x, TMS320C54x, TMS320C55x, TMS320C64x+, TMS320C674x, ARM 9, ARM Cortex R4, and ARM Cortex A8.
- Support targets with 14-pin TI JTAG connector as used by Texas Instruments embedded processors.
- USB bus powered
- Support for USB2.0 High Speed (480 Mbit/s)
- Compatible with +1.8V or +3.3V JTAG interfaces
- Support for Code Composer Studio v4 and newer (Does not support Code Composer Studio v3.3)
- Supports Code Composer Studio™ C2000 On-Chip Flash Programmer.
- Compatible with Windows 2000, XP, and Vista.
XDS100v1 and XDS100v2 (14-pin JTAG header) Comparison
There are 2 versions of the XDS100: 1) XDS100v1 and 2) XDS100v2. The XDS100v1 is TI's original XDS100 design. The two versions have some features in common but the XDS100v2 is an updated XDS100 design with more capabilitiy.
| Features | XDS100v1 | XDS100v2 |
| 1.8v and 3.3v IOs | Yes | Yes |
| JTAG reset/wait-in-reset boot-modes (using EMU0/1 + nTRST) | Yes | Yes |
| Power-on-Reset boot-modes (using EMU0/1 + TVD) | Yes | Yes |
| target power-loss detection (using TVD) | Yes | Yes |
| Supports CCStudio v3.3 | Yes | No |
| Supports CCStudio v4 | No | Yes |
| USB 1.1 Full Speed (12 Mbit/s) | Yes | No |
| USB 2.0 High Speed (480 Mbit/s) | No | Yes |
| 14-pin Jtag header | Yes | Yes |
| Processor Family supported | TMS320C28xx TMS320C54xx TMS320C55xx TMS320C64x+ TMS320C674x | TMS320C28xx |
|
浙公网安备 33011002014637号